P&B Ovington Gelcoat and Catalyst

An isophthalic gelcoat for brush application.

Ovington Gelcoat and Catalyst - 165g

Gelcoat, 8g Catalyst

Carefully formulated to give excellent brushing properties.

The thixotropy has been adjusted to minimise sag on inclined and vertical surfaces.

Approved by Lloyds register of shipping for use in construction of reinforced plastic craft under their survey, and is widely used in the marine and construction industry.

Coverage is approximately 600g per Sq Mt, dependant on operating temperature, therefore 1/2 kg will cover approximately .8 Sq Mt.

If applying gelcoat into a fibreglass (GRP) mould you must always add 2% catalyst, this will prevent the styrene present attacking the waxed surface which ensures the release of the part.

When the gelcoat is tacky (approx 2 hours), you can then start placing and laminating your reinforcement. Never leave more than 24 hours between gelcoating and laminating as the adhesion will be dramatically reduced.

All delivery and returns information can be found here >>

Delivery Information.