This site uses cookies to provide and improve your shopping experience.
If you want to benefit from this improved service, please opt-in.
Cookies Page.
A unique, hard-to-find, pivoting cleat that allows the line to run freely until it is pulled out of alignment. Frequently used for spinnaker halyard pump-up systems.
The halyard exits the mast, goes through a cam cleat and usually a fairlead. Then there is some space before the halyard runs through the pump cleat. On the line in this space there is a trap handle on a block, which you hold to pump. The tail of the halyard then continues through a fairlead or cheek block and is taken up by shock cord. As you pump the handle, the pump-cleat goes out of alignment holding the tail and causing the halyard to take up through the cam cleat. As you lower the handle, the pump cleat aligns again allowing the shock cord to take up the tail through the pump cleat, readying the system for another pump if needed.
Max rope size: 1.5 - 4mm
Length: 40mm
Height: 33.5mm
Hole centres: 18mm
Code:
All delivery and returns information can be found here >>
